SiteMap74HCT4046ADIDT49FCT805BTSOCV5739BDSP3243EEA-L74LCX125MTCLT1780ISWSI4850EY-T1-E3MC836PALC262BSM200GB120DLC Quick Search: 304 GRM TL8 FTS TXC M95 SV1 TA2 MN3 TCE RL5 FDA 724 TYN
Position:Home » DataSheet » LT1 Page No. 20 » LT1316CS8 Suppliers

LT1316CS8 datasheet pdf datenblatt

LT1316CS8 SuppliersLT1316CS8 PriceRelated PDF DownLoad

Ic LT1316CS8

SE9174C is an application of a simple high-speed linear terminal regulator IC, in accordance with JEDECSSTL_2, SSTL_18 to produce stable high-speed DDR bus termination voltage, but also to meet the HSTL, SCSI-2andSCSI-3 and IC LT1316CS8 and other application specific interfaces, both via an external resistor divider to generate the required follow 1/2VDDQ stable terminal voltage can also be produced in REFENPin voltage to the required terminal voltage stability, and provide or absorb the maximum current 2A. At the same time also has a very small SE9174C OFFSET voltage, and over current protection and thermal protection. SE9174C with PSOP-8 (ExposedPAD) package.

LT1316CS8 Suppliers

professional supplier of power management IC think Wang Electronics (SeawardElectronicsInc.) introduction of high-current terminal regulator with high-speed BUS IC-SE9174C. The IC can provide or absorb the maximum current of 2A, with a high cost-effective, ideal for DDRI, DDRII, DDRIII and LT1316CS8 Suppliers and other high-speed memory systems.

LT1316CS8 Price

AD9354 and LT1316CS8 Price and AD9355 operate in 2.3 ~ 2.7GHz and 3.3 ~ 3.7GHz frequency band, and supports 3.5MHz, 4.375MHz, 5MHz, 7MHz, 8.75MHz and 10MHz channel bandwidth. The device has excellent noise figure of 3.25dB (NF) and first-class linearity. When the WiMAX network services increases, these two indicators are able to provide the best practical performance. Smart partitioning architecture supports automatic gain control (AGC), transmitter power control (TPC) and the calibration circuit which significantly saves RF driver development time. In addition, high-accuracy closed-loop power control to transmit power to provide a single point factory calibration, while the other transceivers require 8 to 10 point calibration, thus increasing the cost of final test and extend the development time.

All rights reserved:IcFull.com © 2010-2016